JIMS
Jims Camshaft Bearing Installation Tool - '99-'17 Twin Cam 787
(No reviews yet)
Write a Review
- SKU:
- 3801-0160
- MPN:
- 787
- Condition:
- New
Frequently bought together:
Description
- Use to install the two inner cam bearings
- Designed to press from the letter side of the inner cam bearing to eliminate any damage to the bearings, cam or case
- Will set bearings .023"-.028" below case surface
- Made in the U.S.A.
Related Products
Related Products
Jims Camshaft Assembly Tool - '07-'17 Twin Cam 990
JIMS
MSRP:
$250.74
$218.03
Holds both cams in an upright position while lowering cam support plate over both guides and cam journal guidesMade from a non-marring material that will not damage any of the cams' surfacesMade in...
Jims Camshaft Bearing Puller - Twin Cam 1280
JIMS
MSRP:
$345.46
$300.40
Once the camshafts are removed from the support plate this tool will remove the bearing from the camshaftRemoves bearing straight without binding or slippingMade in the U.S.A.
Jims Bearing Puller Tool - '03-'17 Twin Cam 963
JIMS
MSRP:
$449.13
$390.55
Can also be used to remove Timken? bearing pinion shaft inner bearing race on 57-07 XL, including all Buells?, and used to remove press-fit transmission gears and bearings from input and output...
Jims Crankshaft Bearing Installer - Twin Cam 1146
JIMS
MSRP:
$460.67
$400.58
Designed to protect engine cases by using a specially-designed support block to remove or install cam side crankshaft bearingMade in the U.S.A.
Jims Crankshaft Bearing Tool - Twin Cam 1275
JIMS
MSRP:
$276.93
$240.81
Designed to remove and replace the right crankcase bearingPress bearing in and out straight with no damage to the caseMade in the U.S.A.