ANDREWS

Cams work well with fuel injection or carburetor modelsRun best with low restriction exhausts (1700-5200 rpm)Works well with carbs or fuel injectionBolt-in cam for more torque with stock...

Cams work well with fuel injection or carburetor modelsRun best with low restriction exhausts (1700-5200 rpm)Works well with carbs or fuel injectionBolt-in cam for more torque with stock...

Cams work well with fuel injection or carburetor modelsRun best with low restriction exhausts (1700-5200 rpm)Works well with carbs or fuel injectionBolt-in cam for more torque with stock...

Made in the U.S.A.

Cams work well with fuel injection or carburetor modelsRun best with low restriction exhausts (1700-5200 rpm)Works well with carbs or fuel injectionBolt-in cam for more torque with stock...

Andrews Products grinds its cams with the help of a computer with cam design capabilities. This superior technology gives the utmost in both performance and reliability. Only the best alloy steel...

34 teeth with ignition trigger ringMust use with 99-01 engines with stock ignition02-06 engines can use stock rear cam drive sprocketTrigger ring required for 99-01 engines with rear cam drive...

Cam set is similar to original stock cams but the lobes have been redesigned using modern computer cam design and smoothing techniquesDesigned for use when rebuilding a motor with pitted cams.375"...

Biggest available four-cam set that does not require head work; however, some 82 engines may require spring spacingUses stock springs and provides great mid-range and upper-end powerUse with 9.0:1 to...

Bolt-in four-cam setMore horsepower and torqueStock springs OK to 7000 rpm, requires no headworkMade in the U.S.A.Installer must check coil bind, valve-to-valve clearance, valve-to-piston clearance...

Bolt-in four-cam setMore horsepower and torqueStock springs OK to 7000 rpm, requires no headworkMade in the U.S.A.Installer must check coil bind, valve-to-valve clearance, valve-to-piston clearance...

Bolt-in four-cam setMore horsepower and torqueStock springs OK to 7000 rpm, requires no headworkMade in the U.S.A.Installer must check coil bind, valve-to-valve clearance, valve-to-piston clearance...