Maintenance

Use this tool to remove and install primary inspection plugMade in the U.S.A.

Pulls the bearings from the "B" motor case in one easy smooth motion preventing any damage to the bearing boresInstalling portion is designed to push on the outer diameter of bearings preventing any damage to the bearing or it's boreMade in the U.S.A.

Support plate gives a non-marring, flat surface to push piston bottoms against when installing rings or cylindersMade in the U.S.A.

Use to secure balancers when servicing the flywheel assemblyLock into balancer shaft sprocket pinholes to prevent balancer from turning out of sync with flywheelMade in the U.S.A.

Designed for front and rear 4-piston calipersHolds pistons square in their cylinder bores during removalPrevents damage to pistons and cylinders when installing new seals and wipersMade in the U.S.A. Harley-Davidson -- Wide Glide FXDWG -- (2005, 2003,...

Use to check rod straightness without removing the rods from the casesMade in the U.S.A. Harley-Davidson -- Electra Glide Classic EFI FLHTCI -- (2005, 2012, 2011, 2013, 2010, 2006, 2009, 2008, 1999, 2007, 2001, 2000, 2004, 2003, 2002); Harley-Davidson --...

Designed to protect engine cases by using a specially-designed support block to remove or install cam side crankshaft bearingMade in the U.S.A.

Used for testing electrical circuitsRetractable test leads pull out and stay at desired lengthRewind test leads into its own protective case when not in useHave insulated alligator clips18-gauge copper wire

Used for testing electrical circuitsRetractable test leads pull out and stay at desired lengthRewind test leads into its own protective case when not in useHave insulated alligator clips18-gauge copper wire

Works with bench vise, arbor, screw hydraulic or drill pressTool fits any dual rate or conical valve spring with an O.D. no larger then 1.6?ǥ diameter0 to 1000 P.S.I. gaugeMade in the U.S.A.

Assembly tool features a captive hardened ball bearing dimensionally set 1" from top of toolWorks on all Evolution Big Twin and XL modelsMade in the U.S.A.

Easily installs oil pump seal below gear surface for a no-leak fitFor use on all Big Twin aluminum oil pumps (except Twin Cam/M8)Made in the U.S.A.