Maintenance

Use to install the two inner cam bearingsDesigned to press from the letter side of the inner cam bearing to eliminate any damage to the bearings, cam or caseWill set bearings .023"-.028" below case surfaceMade in the U.S.A.

Harley-Davidson?s? new 6-speed transmission is a very stout piece of engineering, incorporating some of the best bearings madeJIMS? has developed a driver style seal installer (not a pushing or pulling type, which could damage these bearings)Installs...

Tool troubleshoots cylinder leakdown issues such as valve seat issues, bad rings and bad head gasketHose assembly has both 14 mm and 18 mm spark plug threadsIncludes 12 mm and 10 mm adapterMade in the U.S.A.

Required to seal the oil passage way from right case to the balancer tensioner plate; leaking can cause over oiling of the lower end that decreases horsepower from oil dragCan also be used to check pressure lost at the balancer tensioner plateChecks...

Durable, E-Z Grip handle for comfort and a positive gripPipe-threaded end will accept airline quick-disconnect fittingsDesigned for use on hard-to-reach wheelsMade in the U.S.A.

Holds hydraulic tensioners in place that keep constant chain tension on counter balancer systemMade in the U.S.A.

Makes installing shifter shaft seal precise and effortlessAligns, centers and installs shifter seal to correct depthMade in the U.S.A.

Removes and installs O² sensors without removing exhaust pipesMade in the U.S.A.

For use on the Milwaukee Eight? engine series and all Twin Cam motorsThis tool is designed to lock the crankshaft when doing service workJust take out the crank position sensor and install the ?ǣMighty Bite?ǥ into the caseThe tool has an added O-ring to...

Activates starter and rotates engine without startingHandy for tappet adjustments, servicing and diagnosing starting and electrical issuesIncludes 4' lead cable with alligator clip for start positive post terminal and motor post negative hookupsMade in...

Supplies a quick, easy visual check of ignition systemWorks on all ignition systems, including distributorless ignitionsMade in the U.S.A.

Hand tool simplifies the way to verify proper tappet adjustmentAfter adjusting the tappet, simply insert the tip of this tool under the hydraulic unit retaining clip, above the pushrod seatOnly when the tip fits nicely with no endplay is the tappet...