Maintenance

Fine-tooth ratcheting motion will compress the bands in small increments for accurate compressionWill not break or damage ringsMade in the U.S.A.

Use this tool to remove and install primary inspection plugMade in the U.S.A.

Pulls the bearings from the "B" motor case in one easy smooth motion preventing any damage to the bearing boresInstalling portion is designed to push on the outer diameter of bearings preventing any damage to the bearing or it's boreMade in the U.S.A.

Support plate gives a non-marring, flat surface to push piston bottoms against when installing rings or cylindersMade in the U.S.A.

Use to secure balancers when servicing the flywheel assemblyLock into balancer shaft sprocket pinholes to prevent balancer from turning out of sync with flywheelMade in the U.S.A.

Designed to protect engine cases by using a specially-designed support block to remove or install cam side crankshaft bearingMade in the U.S.A.

Used for testing electrical circuitsRetractable test leads pull out and stay at desired lengthRewind test leads into its own protective case when not in useHave insulated alligator clips18-gauge copper wire

Used for testing electrical circuitsRetractable test leads pull out and stay at desired lengthRewind test leads into its own protective case when not in useHave insulated alligator clips18-gauge copper wire

Easily installs oil pump seal below gear surface for a no-leak fitFor use on all Big Twin aluminum oil pumps (except Twin Cam/M8)Made in the U.S.A.

Easily install outer snap ring on oil pump shaft, without over stretching the ringJust apply oil to ring expander, slip ring up to the big end of ring expander, hold up to the end of the shaft, then push ring onto the shaft with sleeveMade in the U.S.A.

Used to remove and install wrist pin bushings without removing connecting rods from crankcasesComes with instructionsMade in the U.S.A.

Lang Tools Thread Chaser Tap - Single-End - Set 1030