Tools

Creates 300-400 lb of static pulling forceCan be used as a snatch strap

Designed for guide removal and installation on all modelsMade in the U.S.A.

Maximize the pulling power your body can produceStrong elastic stretch cord allows a pulling distance of up to four times the distance you can pull by handLets you fully utilize body weight and leg strength when pulling on a stuck snowmobile

"Breaks" the case sealant by pushing apart both case halvesBolts to primary mounting holesUses included hand thread-in pushing screwFlywheels will be pushed from the left caseMade in the U.S.A.

Designed to lock the camshafts and crankshaft sprockets when removing, replacing and torquing the sprocket boltsComes with instructionsMade in the U.S.A.

Used to remove inner cam bearing without damaging the crankcaseTool is also designed to keep rollers from falling into the crankcaseComes with instructionsMade in the U.S.A.

Holds both cams in an upright position while lowering cam support plate over both guides and cam journal guidesMade from a non-marring material that will not damage any of the cams' surfacesMade in the U.S.A.

Inner collar will retain wrench to nut for safer workRemove hex nut from end of main drive gear that secures the rear drive transmission pulleyExtra-long two-piece designMade in the U.S.A.

For use with JIMS® Valve Spring Compressor Tool (PART# DS-196013)Made in the U.S.A.

Safely installs new main transmission case bearing; does not remove bearingHolds bearing square to its bore, eliminating any marring of bearing boreMade in the U.S.A.

Install both bearings and seal with use of a 1-ton pressHolds bearings and seal square to its bore, eliminating any marringInstall bearings and seal to correct depthMade in the U.S.A.

Loosens and removes both shifter shafts from transmission door, allowing further disassembly of transmissionMade in the U.S.A.