Tools

Jims Door Puller - Transmission - '06 Dyna/'07-'17 Big Twin 984

Used to install the main drive gear without removing the transmissionMade in the U.S.A.

Lang Tools Piston Ring Compressor - Fine-Tooth - Set 981

Normally to get access to the top stem nut requires the need to remove the radio packageThis tool allows the ability to loosen, tighten and torque to spec the 1-1/2” stem nut without radio removalSaves up to 45 minutes for an experienced mechanicMade in...

Rotates flywheel/piston assembly with engine still in frame or on a benchThe perfect tool when doing pushrod adjustments, building big-inch engines and checking operating clearancesAlso can be used to keep the flywheel assembly from rotating when...

Rotates flywheel/piston assembly with engine still in frame or on a benchThe perfect tool when doing pushrod adjustments, building big-inch engines and checking operating clearancesAlso can be used to keep the flywheel assembly from rotating when...

Allows installation of shaft bearing on 2006 Harley-Davidson? Dyna Glide and all 07-17 Twin Cam modelsAn adapter for JIMS? Sprocket Shaft Bearing Tool

Remove and install oxygen sensors on fuel-injected modelsSocket tool will withstand up to 125 ft.-lbs. of torqueMade in the U.S.A.

Safely removes and installs inner primary bearing without any damage to new bearing by pushing on outer perimeter of bearingAlso removes and installs inner primary bearing and seal that transmission mainshaft passes throughMade in the U.S.A.

Easily aligns and installs starter jackshaft seal without distorting or damaging sealSeal is located in upper part of inner primary of Big TwinsMade in the U.S.A.

Designed for the 96" and 110" Beta? enginesRemoves both the front and rear counter-balancer shaft bearing assembly, from the left engine caseMade in the U.S.A.

Included in kit is one new steel bearing insert sleeve (held to under .0002" total indicator reading), all necessary drill bits to drill oil feed and return holes, press plate that holds bearing sleeve insert in line with case bearing bore at time of...