JIMS

Make working on motors easier with better accessMade in the U.S.A.

Designed for guide removal and installation on all modelsMade in the U.S.A.

Used to remove inner cam bearing without damaging the crankcaseTool is also designed to keep rollers from falling into the crankcaseComes with instructionsMade in the U.S.A.

Holds both cams in an upright position while lowering cam support plate over both guides and cam journal guidesMade from a non-marring material that will not damage any of the cams' surfacesMade in...

Inner collar will retain wrench to nut for safer workRemove hex nut from end of main drive gear that secures the rear drive transmission pulleyExtra-long two-piece designMade in the U.S.A.

Install both bearings and seal with use of a 1-ton pressHolds bearings and seal square to its bore, eliminating any marringInstall bearings and seal to correct depthMade in the U.S.A.

Loosens and removes both shifter shafts from transmission door, allowing further disassembly of transmissionMade in the U.S.A.

Jims Door Puller - Transmission - '06 Dyna/'07-'17 Big Twin 984

Used to install the main drive gear without removing the transmissionMade in the U.S.A.

Normally to get access to the top stem nut requires the need to remove the radio packageThis tool allows the ability to loosen, tighten and torque to spec the 1-1/2” stem nut without radio...

Allows installation of shaft bearing on 2006 Harley-Davidson? Dyna Glide and all 07-17 Twin Cam modelsAn adapter for JIMS? Sprocket Shaft Bearing Tool

Use to install main drive gear oil seal to the proper depth with transmission assembledIncludes protective sleeve for seal, which can be used to protect main drive gear inner bearings during...