Tools

Inner collar will retain wrench to nut for safer workRemove hex nut from end of main drive gear that secures the rear drive transmission pulleyExtra-long two-piece designMade in the U.S.A.

Safely installs new main transmission case bearing; does not remove bearingHolds bearing square to its bore, eliminating any marring of bearing boreMade in the U.S.A.

Install both bearings and seal with use of a 1-ton pressHolds bearings and seal square to its bore, eliminating any marringInstall bearings and seal to correct depthMade in the U.S.A.

Loosens and removes both shifter shafts from transmission door, allowing further disassembly of transmissionMade in the U.S.A.

Jims Door Puller - Transmission - '06 Dyna/'07-'17 Big Twin 984

Used to install the main drive gear without removing the transmissionMade in the U.S.A.

Lang Tools Piston Ring Compressor - Fine-Tooth - Set 981

Normally to get access to the top stem nut requires the need to remove the radio packageThis tool allows the ability to loosen, tighten and torque to spec the 1-1/2” stem nut without radio removalSaves up to 45 minutes for an experienced mechanicMade in...

Rotates flywheel/piston assembly with engine still in frame or on a benchThe perfect tool when doing pushrod adjustments, building big-inch engines and checking operating clearancesAlso can be used to keep the flywheel assembly from rotating when...

Allows installation of shaft bearing on 2006 Harley-Davidson? Dyna Glide and all 07-17 Twin Cam modelsAn adapter for JIMS? Sprocket Shaft Bearing Tool

Remove and install oxygen sensors on fuel-injected modelsSocket tool will withstand up to 125 ft.-lbs. of torqueMade in the U.S.A.

Safely removes and installs inner primary bearing without any damage to new bearing by pushing on outer perimeter of bearingAlso removes and installs inner primary bearing and seal that transmission mainshaft passes throughMade in the U.S.A.