Tools

Fine-tooth ratcheting motion will compress the bands in small increments for accurate compressionWill not break or damage ringsMade in the U.S.A.

For big-inch or high compression Twin CamsWorks on front and back head, with or without valves installedSimply drill, spot face, tap and install compression release valvesInstallation kit includes fixture, drill bit, spot face bit and thread-tapping tool

Use this tool to remove and install primary inspection plugMade in the U.S.A.

Pulls the bearings from the "B" motor case in one easy smooth motion preventing any damage to the bearing boresInstalling portion is designed to push on the outer diameter of bearings preventing any damage to the bearing or it's boreMade in the U.S.A.

Support plate gives a non-marring, flat surface to push piston bottoms against when installing rings or cylindersMade in the U.S.A.

Use to secure balancers when servicing the flywheel assemblyLock into balancer shaft sprocket pinholes to prevent balancer from turning out of sync with flywheelMade in the U.S.A.

Use to check rod straightness without removing the rods from the casesMade in the U.S.A. Harley-Davidson -- Electra Glide Classic EFI FLHTCI -- (2005, 2012, 2011, 2013, 2010, 2006, 2009, 2008, 1999, 2007, 2001, 2000, 2004, 2003, 2002); Harley-Davidson --...

A must-have tool for 45A charging systems; will also work on any Harley-Davidson® alternator system that has threaded puller holesTool protects threads on sprocket shaft from damage while pulling rotor free from its magnetic holdMade in the U.S.A.

Designed to protect engine cases by using a specially-designed support block to remove or install cam side crankshaft bearingMade in the U.S.A.

Used for testing electrical circuitsRetractable test leads pull out and stay at desired lengthRewind test leads into its own protective case when not in useHave insulated alligator clips18-gauge copper wire

Used for testing electrical circuitsRetractable test leads pull out and stay at desired lengthRewind test leads into its own protective case when not in useHave insulated alligator clips18-gauge copper wire

Assembly tool features a captive hardened ball bearing dimensionally set 1" from top of toolWorks on all Evolution Big Twin and XL modelsMade in the U.S.A.